1. It is suitable for the transmission with the axis angle β<45°of the two axis on the same plane
2. 11.2-1120N.m : nominal torque 11.2-1120N.m
3. Maximum bending angle 45° per joint.
4. Finished product hole tolerance H7, keyway, hexagonal hole and square hole can order as requirement .
5. Angle between the two axes can change with the machines needs within a limited range.
6. sliding bearings and needle bearings both acceptable, it’s depending on user requirements. The maximum speed with sliding bearing is 1000rpm, the dynamic load with needle bearing is higher, the bearing clearance is small, and the maximum speed can reach 4000rpm.
This universal shaft coupling most used in boat ,marine,industry ,motion automatation indtusry ,and verious kinds of machiney .Let see it drawings and parameters.
AS above size chart ,you can see we can offer different size and different hole type for those u joint shaft coupling,(cv joint ),even different material. We have making those product for 19 years ,we offer to demestic verious trading company and machinery plant ,for international ,we had distributor to France ,Germany ,Russia ,Thailand South Africa and ohter high quality required coutries.
Automatic lock screw machine
In-Plant Utility Vehicles
Installation and Selection:
To ensure angular velocity of rotational motion between the driving and driven shaft under synchronous rotation,should choose double cross shaft universal joint or two single cross shaft universal joint connect together ,also need meet the following 3 conditions :a)the angle of intermediate shaft between driving and driven shaft should equal ,b)The symmetry surfaces of the two ends of the intermediate shaft are in the same plane ,c)When the intermediate shaft and the driven shaft in the same plane to install the single shaft universal joint, the angle of driving and driven is different ,can not keep synchronous operation,will change with the angle .