1. It is suitable for the transmission with the axis angle β<45°of the two axis on the same plane
2. 11.2-1120N.m : nominal torque 11.2-1120N.m
3. Maximum bending angle 45° per joint.
4. Finished product hole tolerance H7, keyway, hexagonal hole and square hole can order as requirement .
5. Angle between the two axes can change with the machines needs within a limited range.
6. sliding bearings and needle bearings both acceptable, it’s depending on user requirements. The maximum speed with sliding bearing is 1000rpm, the dynamic load with needle bearing is higher, the bearing clearance is small, and the maximum speed can reach 4000rpm.
The drawings of the WX WXD double joint drive shaft coupling
The parameters of the small precision prop shaft coupling
Notes:WX =double joint
a. Coupling Model: WXD-single cross type; WX-double cross type. B-axis hole pattern: a cylindrical hole with taper bolt hole; Y-key cylindrical hole with set screw . Shaft hole and key type and size comply with GBT3852-197 regulations .S:square hole with set screw;F-Hexagonal hole with sets screw .
b WX4 double cross shaft universal coupling. Drive end: Y-type shaft hole, A-nomal keyway, d = 16mm, driven end: S-shaft hole, w = 18mm, marked as: WX4YA16S18
Automatic lock screw machine
Tractors pump boat ,motor ,electric motor
In-Plant Utility Vehicles
Installation and Selection:
To ensure angular velocity of rotational motion between the driving and driven shaft under synchronous rotation,should choose double cross shaft universal joint or two single cross shaft universal joint connect together ,also need meet the following 3 conditions :a)the angle of intermediate shaft between driving and driven shaft should equal ,b)The symmetry surfaces of the two ends of the intermediate shaft are in the same plane ,c)When the intermediate shaft and the driven shaft in the same plane to install the single shaft universal joint, the angle of driving and driven is different ,can not keep synchronous operation,will change with the angle .